Understanding Gateway Load Balancing Protocol (GLBP) Gateway Load Balancing Protocol (GLBP) is a Cisco proprietary solution for redundancy and load balancing in an IP network. GLBP allow automatic selection and simultaneous recovery from first hop router failures. GLBP is designed to overcome some of the limitations of earlier First Hop Redundancy Protocols (FHRPs) such as Hot Standby Router… Read More »
The routing table is a fundamental component of network devices like routers, which directs incoming data packets to their destination addresses by providing a set of rules for packet forwarding. Below is a brief introduction to the essential components of a routing table: i. Routing Protocol Code The routing protocol code identifies the source of the routing information.… Read More »
NTP – An Overview. Network Time Protocol (NTP) is an essential internet protocol, developed by David L. Mills of the University of Delaware, that is designed to synchronize clocks of networked computers to within a few milliseconds of Coordinated Universal Time (UTC). Its significance cannot be overstated, as accurate timekeeping is important for the functioning of various applications… Read More »
There have been a sheer number and variety of protocols developed over the years for different layers, purposes, and technologies in network communication. However, here is a categorization of some of the most used and significant networking protocols according to their primary area of operation or the layer of the OSI (Open Systems Interconnection) model they typically function… Read More »
What are IP Management Access Connections? In wireless networking, AP (Access Point) and WLC (Wireless LAN Controller) management access connections refer to the methods and protocols used to configure, manage, and monitor these devices. AP (Access Point): An Access Point is a device that creates a wireless local area network (WLAN), usually in an office or large building.… Read More »
